Vacuum-gap-based lumped element Josephson parametric amplifier

We propose a lumped element Josephson parametric amplifier with vacuum-gap-based capacitor.The capacitor is made of quasi-floating aluminum pad and on-chip ground.We take a fabrication process compatible with air-bridge technology,which makes our design adaptable for future on-chip integrated quantum computing system.Further engineering the input impedance,we obtain a gain above 20 dB over 162-MHz bandwidth,along with a quasi quantum-limit noise performance.This work should facilitate the development of quantum information processing and integrated superconducting circuit design.     

石墨烯负载的氧配位钴单原子稳定金属锂负极

Lithium (Li)-based batteries are the dominant energy source for consumer electronics, grid storage, and electrified transportation. However, the development of batteries based on graphite anodes is hindered by their limited energy density. With its ultrahigh theoretical capacity (3860 mAh∙g⁻¹), low redox potential (−3.04 V), and satisfactorily low density (0.54 g∙cm⁻³), Li metal is the most promising anode for next-generation high-energy-density batteries. Unfortunately, the limited cycling life and safety issues raised by dendrite growth, unstable solid electrolyte interphase, and "dead Li" have inhibited their practical use. An effective strategy is to develop a suitable lithiophilic matrix for regulating initial Li nucleation behavior and controlling subsequent Li growth. Herein, single-atom cobalt coordinated to oxygen sites on graphene (Co-O-G SA) is demonstrated as a Li plating substrate to efficiently regulate Li metal nucleation and growth. Owing to its dense and more uniform lithiophilic sites than single-atom cobalt coordinated to nitrogen sites on graphene (Co-N-G SA), high electronic conductivity, and high specific surface area (519 m²∙g⁻¹), Co-O-G SA could significantly reduce the local current density and promote the reversibility of Li plating and stripping. As a result, the Co-O-G SA based Li anodes exhibited a high Coulombic efficiency of 99.9% at a current density of 1 mA∙cm⁻² with a capacity of 1 mAh∙cm⁻², and excellent rate capability (high current density of 8 mA∙cm⁻²). Even at a high plating capacity of 6 mAh∙cm⁻², the Co-O-G SA electrode could stably cycle for an ultralong lifespan of 1300 h. In the symmetric battery, the Co-O-G SA based Li anode (Co-O-G SA/Li) possessed a stable voltage profile of 18 mV for 780 h at 1 mA∙cm⁻², and even at a high current density of 3 mA∙cm⁻², its overpotential maintained a small hysteresis of approximately 24 mV for > 550 h. Density functional theory calculations showed that the surface of Co-O-G SA had a stronger interaction with Li atoms with a larger binding energy, −3.1 eV, than that of Co-N-G SA (−2.5 eV), leading to a uniform distribution of metallic Li on the Co-O-G SA surface. More importantly, when matched with a sulfur cathode, the resulting Co-O-G SA/lithium sulfur full batteries exhibited a high capacity of 1002 mAh∙g⁻¹, improved kinetics with a small polarization of 191 mV, and an ultralow capacity decay rate of 0.036% per cycle for 1000 cycles at 0.5C (1C = 1675 mA∙g⁻¹) with a steady Coulombic efficiency of nearly 100%. Therefore, this work provides novel insights into the coordination environment of single atoms for the chemistry of Li metal anodes for high-energy-density batteries.     

Manage Pension Deficit with Heterogeneous Insurance

This paper considers a positive and increasing pension deficit of a certain pay-as-you-go (PAYG) pension system, and tries to make up for this deficit by using heterogeneous insurance. The positive pension deficit is formulated as a mathematical function in continuous time. The surplus of an appropriate heterogeneous insurance is described by diffusion approximation of a Cramér-Lundberg process. The system of extended Hamilton-Jacobi-Bellman equations under mean-variance criterion is established. The closed-form solution and optimal surplus-multiplier of heterogenous insurance are obtained. Some interpretations further explain the theoretical values of the results.

     

Quantitative Analysis of Al in Flour Products by Laser-Induced Breakdown Spectroscopy Combined with Partial Least Squares

Journal of Applied Spectroscopy - Based on partial least squares (PLS) analysis, the effects of different smoothing points and different preprocessing methods on the accuracy and precision of the...     

Semiconducting Polymer Dots with Dual-Enhanced NIR-IIa Fluorescence for Through-Skull Mouse-Brain Imaging

Fluorescence probes in the NIR-IIa region show drastically improved imaging owing to the reduced photon scattering and autofluorescence in biological tissues. Now, NIR-IIa polymer dots (Pdots) are developed with a dual fluorescence enhancement mechanism. First, the aggregation induced emission of phenothiazine was used to reduce the nonradiative decay pathways of the polymers in condensed states. Second, fluorescence quenching was minimized by different levels of steric hindrance to further boost the fluorescence. The resulting Pdots displayed a fluorescence QY of ca. 1.7 % in aqueous solution, suggesting an enhancement of ca. 21 times in comparison with the original polymer in tetrahydrofuran (THF) solution. Small-animal imaging by using the NIR-IIa Pdots exhibited a remarkable improvement in penetration depth and signal to background ratio, as confirmed by through-skull and through-scalp fluorescent imaging of the cerebral vasculature of live mice.     

基于NiCo2O4纳米片电极的非对称混合电容器

The looming global energy crisis and ever-increasing energy demands have catalyzed the development of renewable energy storage systems. In this regard, supercapacitors (SCs) have attracted widespread attention because of their advantageous attributes such as high power density, excellent cycle stability, and environmental friendliness. However, SCs exhibit low energy density and it is important to optimize electrode materials to improve the overall performance of these devices. Among the various electrode materials available, spinel nickel cobaltate (NiCo₂O₄) is particularly interesting because of its excellent theoretical capacitance. Based on the understanding that the performances of the electrode materials strongly depend on their morphologies and structures, in this study, we successfully synthesized NiCo₂O₄ nanosheets on Ni foam via a simple hydrothermal route followed by calcination. The structures and morphologies of the as-synthesized products were characterized by X-ray diffraction, scanning electron microscopy, and Brunauer-Emmett-Teller (BET) surface area analysis, and the results showed that they were uniformly distributed on the Ni foam support. The surface chemical states of the elements in the samples were identified by X-ray photoelectron spectroscopy. The as-synthesized NiCo₂O₄ products were then tested as cathode materials for supercapacitors in a traditional three-electrode system. The electrochemical performances of the NiCo₂O₄ electrode materials were studied and the area capacitance was found to be 1.26 C·cm^-2 at a current density of 1 mA·cm^-2. Furthermore, outstanding cycling stability with 97.6% retention of the initial discharge capacitance after 10000 cycles and excellent rate performance (67.5% capacitance retention with the current density from 1 to 14 mA·cm^-2) were achieved. It was found that the Ni foam supporting the NiCo₂O₄ nanosheets increased the conductivity of the electrode materials. However, it is worth noting that the contribution of nickel foam to the areal capacitance of the electrode materials was almost zero during the charge and discharge processes. To further investigate the practical application of the as-synthesized NiCo₂O₄ nanosheets-based electrode, a device was assembled with the as-prepared samples as the positive electrode and active carbon (AC) as the negative electrode. The assembled supercapacitor showed energy densities of 0.14 and 0.09 Wh·cm^-3 at 1.56 and 4.5 W·cm^-3, respectively. Furthermore, it was able to maintain 95% of its initial specific capacitance after 10000 cycles. The excellent electrochemical performance of the NiCo₂O₄ nanosheets could be ascribed to their unique spatial structure composed of interconnected ultrathin nanosheets, which facilitated electron transportation and ion penetration, suggesting their potential applications as electrode materials for high performance supercapacitors. The present synthetic route can be extended to other ternary transition metal oxides/sulfides for future energy storage devices and systems.     

Multi-emissive 1D Cd(II) polymers with a biphenyl bridged bisazamacrocycle for ratiometric discrimination of nitroaromatics and selective visual detection of picric acid

Three one-dimensional ladder-like coordination polymers consisting of Cd₆ metalloring as the building unit, {[Cd₄LCl₄]·3H₂O}_n ( 1 ), {[Cd₃L(ClO₄)(H₂O)]ClO₄·3H₂O}_n ( 2 ), and {[Cd₆(L)₂(NO₃)₂(CH₃OH)(H₂O)](NO₃)₂·2CH₃OH·5H₂O}_n ( 3 ), were solvothermally constructed from a carboxylic functionalized bisazamacrocyclic ligand 4,4′-bis((4,7-bis(2-carboxyethyl)-1,4,7-triazacyclonon-1-yl)methyl)-1,1′-biphenyl (H₄L). These compounds dispersed in ethanol show the multiple emissions originating from the monomeric and intramolecularly overlapping biphenyl moieties which could be sensitively quenched by picric acid (PA) and 4-nitrophenol (4-NP) through the effective fluorescence resonance energy transfer process. The differential fluorescent responses of each compound on exposure to PA and 4-NP individually make the convenient ratiometric discrimination of two analytes based on the fluorescent intensity ratio (I₃₂₀/I₃₆₀) attainable, and 1 and 2 as ratiometric chemosensors for PA present a broad linear detection range from 4 to 300 μM with detection limits of 0.84 and 0.93 μM, respectively. Furthermore, the blue light emission of 1 under an ultraviolet lamp could be selectively quenched by PA even in the presence of all other interfering nitroaromatic pollutants, which empowers the fast visual detection of PA by naked eye.     

Nickel (II) tetrapyridyl complexes as electrocatalysts and precatalysts for water oxidation

Two nickel complexes, [Ni(tpen)](ClO₄)₂.0.5CH₃COCH₃ ( 1 ) and [Ni(tpbn)](ClO₄)₂ ( 2 ), of tetrapyridyl ligands N,N,N′,N′-tetrakis(2-pyridyl-methyl)-1,2-ethanediamine (tpen) and N,N,N′,N′-tetrakis(2-pyridyl-methyl)-1,4-butanediamine (tpbn) were prepared and their catalysis for water oxidation reaction (WOR) studied. In 0.1 M phosphate buffer solution (PBS) of pH 8.0, complex 1 is a homogeneous molecular catalyst with an overpotential of ~440 mV and a Faradaic efficiency of 89%. At pH ≥ 9.0, complex 1 degraded gradually during the catalytic process and formed NiO_x composite (nickel oxide with general formula Ni_xO_yH_z) active for WOR. In contrast, complex 2 deteriorated under measured conditions (pH 8.0–12.0) and formed NiO_x composite active for WOR. The NiO_x composite derived from 1 in 0.1 M PBS at pH 11.0 showed an activity with an overpotential of ~500 mV, a Tafel slope of ~90 mV/decade and a Faradaic efficiency of 97%. Mechanisms were proposed for water oxidation catalyzed by 1 and 2 . This work revealed that the catalytic activity of the nickel complexes was related to the flexibility of the tetrapyridyl ligands and the adaptability of the coordination sphere of the nickel(II) center.     

Halloysite nanotubes: an eco-friendly adsorbent for the adsorption of Th(IV)/U(VI) ions from aqueous solution

Journal of Radioanalytical and Nuclear Chemistry - In this study, the halloysite nanotubes was characterized and the adsorption of Th(IV) and U(VI) on halloysite nanotubes was investigated as a...     

Adaptive controller design for a switched model of air-breathing hypersonic vehicles

Since most of the control strategies for air-breathing hypersonic vehicles (AHVs) concentrate on the control-oriented models built at/around a specific working point, it is somewhat hard to extend them to the broader flight envelop. Aiming at the above deficiency, this paper formulates the dynamics of AHVs as several sub-models, which switch to each other in accordance with the flight condition and make up of the control-oriented switched model (COSM). With the aid of the COSM, two adaptive tracking controllers are proposed for the purposes of velocity tracking and altitude tracking, sequentially. By utilizing neural networks and designing robust control laws, the possible changes on the force and moment coefficients in the COSM are successfully handled. The time-varying inertia parameters of AHVs are also considered at design level. It is worth emphasizing that while this strategy is developed based on a switched model, the resulting control algorithm is continuous with no connection to the switching signal. Analysis indicates that both velocity and altitude tracking errors remain small within the whole flight envelop, which is further confirmed by a simulation study.